go1984 can aggregate recordings made during a certain interval to so-called scenes. This makes it much easier to find them later. The concept used is quite simple. Any scene that has already begun will be continued if less time than defined in the field "Time interval" has passed. If more time has passed, a new scene is generated. You can also define that a new scene should be generated as soon as the scene file becomes larger than the value entered into the field "File size" or if the current scene is longer than the value entered into the field "Duration".
The following criteria specifically apply for generating scenes. Once again, if more than one criterion is relevant, the first criterion to be met is decisive:
no motion was detected for this time interval: |
if the time between two recordings triggered by motion detection is less than specified here, the scene already begun is continued. But if this time is exceeded a new scene is generated. The same applies if the recording is triggered by a signal other than internal motion detection (e.g. by a camera’s digital input signal or by an http event). |
the size of the scene file is greater than: |
a new scene is generated if the current scene exceeds the size specified here. |
the duration of the scene is longer than: |
if the scene duration specified here is exceeded a new scene is generated. If scenes are recorded by default only when there is a detected motion, the scene generated in this case will usually cover a longer period than specified under this point. |
